Model No.: SN6X-2S
1. 6 years OEM & ODM Factory;
2. STRICT QC;
3. ANSL/NEMA FL1-2009 Standard;
4. CE, ROHS, FCC Approved;
Maxtoch SN6X-2S Deep Reflector 1200LM XM-L2 CREE XML2 LED Flashlight Features:
*LED Type: CREE XM-L2
*Max output: 1200LM
*Beam: Smooth Reflector for focused beam
*Lens: Toughened ultra-clear glass *Finish: HA III
*Switch: Tail cap switch
*Modes: Max-Mid-Min *Battery: 2*18650 or 4*CR123A
*Circuit efficiency: 85%
*Size: L 248 mm (9.76'') *D 63.2 mm (2.49'') Operation:
*Press tail switch for turning light on/off.
*With the light turned off, gently press (no click) the forward tail switch, the brightness level will switch between three functions or "click" is heard will change the function and turn on.
*Remove the tail cap, insert the batteries with the positive ends toward the head of the light, replace the tail cap. Parameters:
|Max Output ( lm )||1200||Runtime ( H )||1.5|
|Distance ( m )|| |
2* 18650 or 4 * CR123A
|Weight ( g )||406||Size ( mm )||248 * 63.2|
Output & Runtime:
*Max output of 1200 lumens for approximately 1.5 Hours
*Mid output of 625 lumens for approximately 3.4 Hours
*Min output of 260 lumens for approximately 8.4 Hours
Note: Stated brightness and runtime figures are based on tests using 2PCS 18650 Li-ion batteries (approximate 3000mAH) under laboratory conditions. Variances in these figures will occur depending on batteries used and individual usage habits. Contact us if you need more details on Flashlight. We are ready to answer your questions on packaging, logistics, certification or any other aspects about Led Flashlight、Cree Xml2 Led Flashlight. If these products fail to match your need, please contact us and we would like to provide relevant information.
Deep well pump installation requirements: First, the deep well pump assembly requirements: 1, the assembly pump, Yang pipe, drive shaft, should be fastened after the connector and gradually into the well, prevent mechanical parts and tools fall into the well, submersible power Pump cable should be bundled in the Yang pipe;...
Deep well pump installation requirements and inspection: First, diving deep well pump should still make the following inspection: 1 electrical connector should be immersed in water for 6 hours, with 5000 V shake table measurement, the insulation resistance of not less than 5 Megohm; On the blue protective cable groove,...
Submersible deep well pump should also be checked as follows: 1. The electrical connector should be immersed in water for 6 hours, with 5000 V shake table measurement, the insulation resistance of not less than 5 megohms; 2. The flange on the cable groove, there must be no Burrs or sharp corners, and should be cleaned; 3....
Deep well pump working principle introduction Deep well pump working principle is to raise water from the well vane pump, long shaft deep well pump is a more widely used deep well pump, a pump, generally used for machine wells. Deep well pump is mainly composed of three parts: the top is the motor, installed in the middle...
Product Categories : Hunting Flashlight
Premium Related Products